CI830 3BSE013252R1 ABB Profibus Communication Interface

Product Type Communication_Module

Protocol Type Profibus-DP

Number of Channels 1

Communication Speed 12000 kbit/s

CI830 Profibus Communication Interface

Including: Firmware SW 1.4/2

1 pce Power Supply Connector (  3BSC840098R1 )

1 pce TB807 Modulebus Terminator

Some of the benefits of the S800 I/O system are:

• Flexibility, permitting a virtually infinity number of installation arrangements for any application:

– small to large

– easy mounting on a DIN rail

– etc.

• Modularity, permitting step-by-step expansion

• Cost-effectiveness, making you save on hardware, cabling, installation and maintenance

• Reliability and auto-diagnostics

• Saves panel costs

• Reduces downtime

• Easy to configure

• Redundancy can be introduced on all levels

The major features of the S800 I/O system are:

• Communicates over PROFIBUS-DP/DPV1 or Advant Fieldbus 100.

• Quick faultfinding with help of LEDs of each module and channel.

• An extensive scope of Digital input/output modules and Analog input/output modules.

• Digital input/output modules and Analog input/output modules with Intrinsic Safety interfaces.

• Mounted on standard DIN rails type NS 35/75 according to EN 50022.

• Support of dual redundancy in power supply, fieldbus connection and I/O channel.

• Support of fieldbus media supervision, bumpless change-over and failure reporting.

• All outputs can be individually set to freeze or to take on predefined values.

• Easy connection to drives systems, minimizing communication delays and cost.

• All modules have plastic injection molded enclosures which provide safety protection degree IP20 according to IEC 529. The plastic used is halogen free.

• I/O modules are protected from destruction by a mechanical keying arrangement if an attempt is made to insert a module type in a position with a different key code than the factory set code of the I/O module. Terminal units have keys which are set to key code of its I/O module’s key code. (S800L I/O modules do not use Termination Units).

• An electrical ID is checked at start-up, if this does not match the configured type, the I/O module is not taken into operation.

• Hot-swap of S800 I/O modules (except S800L modules) allowing replacement of faulty modules without disconnecting field power or system power to the I/O-station.

• HART pass-through communication.