China Series SUP300 High Power Resistor Manufacturer and Supplier

Series SUP300 High Power Resistor

Short Description:

Mainly used as a snubber resistor to compensate the C-R peaks in traction power supplies. Furthermore for speed drives, power supplies, control devices and robotics. The easy mounting fixture guarantees an auto-calibrated pressure to the cooling plate of about 300 N.

■300W operating power

■Non-Inductive design

■ROHS compliant

■Materials in accordance with UL 94 V-0

Send email to us Download as PDF

Product Detail

Product Tags

Derating

Derating (thermal resist.) SUP300: 4.24W/K (0.24 K/W)
Power rating: 300 W at 85°C bottom case temperature
This value is only applicable when using a thermal conduction to the heat sink Rth-cs<0.025K/W. This value can be obtained by using a thermal transfer compound with a heat conductivity of at least 1 W/mK. The flatness of the cooling plate must be better than 0.05 mm overall. Surface roughness should not exceed 6.4 μm.

Dimensions in millimeters

Specifications

Resistance ranges：0.1 Ω ≤ 0.2Ω (HC-version)
> 0.2Ω ≤ 1 MΩ (higher values on request)
Resistance Tolerance： ±5% to ± 10 %
±1 % to ±2 % on special request for limited ohmic values with the reduction of the max. power / pulse rating (ask for details)
Temperature Coefficient： ±500PPM/℃(0.1 Ω ≤ 0.2Ω) standard
±150PPM/℃(> 0.25 Ω ≤ 1 MΩ) standard
lower TCR on special request for limited ohmic values
Power rating:300 W at 85°C bottom case temperature
Short time overload： 360 W at 70°C for 10sec., ΔR = 0.4% max.
Maximum operating voltage：5,000 V DC = 3.500 V AC RMS (50 Hz)
higher voltage on request, not exceeding max. power
Electric strength voltage：7 kVrms / 50 Hz / 500 VA, test time 1 min
between terminal und case (up to 12 kVrms on request)
voltages above 10 kVrms are tested at DC equivalent to avoid pre
damage of component
Insulation resistance：> 10 GΩ at 1,000 V
Single shot voltage：up to 12 kV norm wave (1.5/50 μsec)
Creeping distance：> 29mm (standard, higher on request)
Air distance：> 14 mm (standard, higher on request)
Inductance：≤ 80 nH (typical), measuring frequency 10 kHz
Capacity/mass：≤ 140 pF (typical), measuring frequency 10 kHz
Capacity/parallel：≤ 40 pF (typical), measuring frequency 10 kHz
Operating temperature：-55°C to +155°C
Mounting – torque for contacts：1.8 Nm to 2 Nm
Mounting – torque：1.6 Nm to 1.8 Nm M4 screws
Cable variation available on request：HV-cable / Flying leads (ask for details)
Standard cable type：H&S Radox 9 GKW AX 1,5mm2 (other cable types on special request)
Weight: ~73.3g